Barco DP2K-12C Installation Manual page 18

2. General
9. Resetting the lamp parameters. The "LAMP INFO" parameters which are stored on the controller board of the projector MUST
be updated after each installation of an xenon lamp inside the lamp house. Neglecting this update will result in poor performance
and short life time of the xenon lamp. See chapter "Resetting the lamp parameters", page 34.
10.Realignment of the xenon lamp in its reflector. For optimal performance of the xenon lamp it is required to realign the lamp
after installation in the lamp house. See "Realignment of the lamp in its reflector", page 35 for more information.
11. Adjusting the light path. Normally the lens holder and the convergence of the projector is perfectly adjusted at the factory.
Nevertheless, some applications require a readjustment of the lens holder, convergence or both. See procedure "Scheimpflug
adjustment", page 42, to adjust the Scheimpflug and see chapter "Convergence", page 87 to adjust the convergence of the light
path.
12.Registration of the projector. The DP2K C-series projector is DCI compliant and should be registered by Barco. Therefore,
the digital certificate inside the projector will be used to secure encryption key communication between the projector and the rest
of the theatre system (server and theatre management system). For more info see chapter "Projector registration", page 59.
13.Projection of a digital cinema movie. Apply a single or dual channel SMPTE or DVI source to the input ports of the projector
and start up the projector. See "Source input ports of the DP2K C-series projector", page 50 and chapter "Starting up", page 57.
Use the Communicator Touch Panel to configure the applied source. See the user guide of the Communicator Touch Panel for
more detailed information.
12 R5905050 DP2K C-SERIES 10/07/2012