Removal Of The Lamp House - Barco DP2K-12C Installation Manual

Supported xenon bulb lamps (without lamp house)
Lamp
Osram xenon lamp of 4 kW
Osram xenon lamp of 3 kW
Osram xenon lamp of 2 kW
Osram xenon lamp of 1.2kW
Ushio xenon lamp of 4 kW
Ushio xenon lamp of 3 kW
Ushio xenon lamp of 2 kW
Ushio xenon lamp of 2 kW
Ushio xenon lamp of 1.2kW
Philips xenon lamp of 4 kW
X = lamp is available for this projector.
- = lamp cannot be used in this projector.
4.2

Removal of the lamp house

W
ARNING
C
AUTION
minutes before proceeding to the lamp unit replacement.
C
AUTION
handled.
Necessary tools
• Flat screw driver or
• Nut driver 8mm
How to remove the lamp house of the projector
1. Switch off the projector.
2. Remove the lamp cover.
3. Release the three spring lock screws of the lamp house as illustrated.
R5905050 DP2K C-SERIES 10/07/2012
Type
4kW DHP
3kW DHP
2kW DHP
1200W DHP
DXL40BAF
DXL30BAF
DXL20BAF
DXL20BAF/2
DXL12BAF
XDC-4000B
:
This procedure may only be performed by qualified technical service personnel.
:
Lamp casing is very hot after operation. To avoid burns, let the projector cool down for at least 15
:
Due to its high internal pressure, the lamp may explode in either hot or cold states if improperly
Order info DP2K-12C
-
R9855937
-
R9855938
R9855956 X
R9855959 X
-
R9855939
-
R9855940
R9855955 X
R9855965 X
R9855961 X
-
R9856370
4. Lamp & Lamp House
DP2K-15C DP2K-20C
-
X
X X
X X
X X
-
X
X X
X X
X X
X X
-
X
23