Removal And Installation Of Projector Covers; Removal Of The Lamp Cover - Barco DP2K-12C Installation Manual

10. REMOVAL AND INSTALLATION OF PROJECTOR
COVERS
About this chapter
Most maintenance and servicing procedures demand removing one or more of the projector covers to gain access to the parts to
maintain or to service. To avoid redundancy, all procedures about cover removing or installing are grouped together in this chapter.
The maintenance and servicing procedures also refer to this chapter if required. The procedures in this chapter describe, with
detailed step by step actions and illustrations, how to remove or install the projector covers. Note that some covers may only be
removed by qualified service personnel, see remarks above each procedure.
W
ARNING
unless otherwise stated.
Overview
•

Removal of the lamp cover

• Removal of the input cover
• Removal of the front cover
• Removal of the side cover
• Removal of the rear cover
• Removal of the top cover
• Open the sealed compartment
• Close the sealed compartment
• Installation of the top cover
• Installation of the rear cover
• Installation of the side cover
• Installation of the front cover
• Installation of the input cover
10.1 Removal of the lamp cover
W
ARNING
Necessary tools
Flat screw driver.
How to remove the lamp cover of the projector?
1. Release the two captive screws at the right side, top and bottom, of the lamp cover, using a flat screw driver.
Image 10-1
Release lamp cover
R5905050 DP2K C-SERIES 10/07/2012
:
Always switch off the projector and unplug the power cord before removing one of the covers,
:
This procedure may only be performed by qualified technical service personnel.

10. Removal and installation of projector covers

67