Initial Inspection; Box Content - Barco DP2K-12C Installation Manual

2. General
Image 2-4
9. Remove the projector from the wooden support plate and finally remove the 3 extension tubes (reference 6). Use a 17 mm
wrench.
Image 2-5
Save the original shipping carton and packing material, they will be necessary if you ever have to ship your
projector. For maximum protection, repack your projector as it was originally packed at the factory.
A rubber foam inside a plastic bag is placed into the lens opening of the projector. It's recommended to reuse
this foam and plastic back each time you transport the projector. This to prevent intrusion of dust and foreign
particles.
The lens is delivered in a separate box. For lens installation, see section "Lens & lens holder".
2.3

Initial inspection

General
Before shipment, the projector was inspected and found to be free of mechanical and electrical defects. As soon as the projector is
unpacked, inspect for any damage that may have occurred in transit. Save all packing material until the inspection is completed. If
damage is found, file claim with carrier immediately. The Barco Sales and Service office should be notified as soon as possible.
The packaging of the DP2K C-series projector is provided with a shock-watch label. If this shock-watch la-
bel was triggered (red colored at arrival) during transport, indicates that the package was possibly roughly
handled by the transport company. In this case, the instructions mentioned on the label, should be followed,
which are: adding a note on the "bill of lading" and informing the transport company and the Barco sales and
service office as soon as possible.

Box content

After unpacking the projector it is recommended to check if all following items where included:
10
5
6
R5905050 DP2K C-SERIES 10/07/2012
6