Installing The Touch Panel Interface - Barco DP2K-12C Installation Manual

7. Communicator touch panel
A Touch screen
B Communication panel
Knob to operate central swivel clamp
C
D Base of swivel arm
E Power input 12 VDC, 1.5A
F RS232 port (sub-D)
G Ethernet port (RJ45)
C
AUTION
7.2

Installing the touch panel interface

Necessary tools
• 17 mm wrench.
• 10 mm wrench.
How to install the touch panel interface upon the DP2K C-series projector?
1. Assemble the mounting plate and the swivel arm together as illustrated. First place the nut (N) upon the rod of the mounting
plate, then add the lock washer (L), then fasten the mounting plate and the swivel arm together. When the arm is mounted, turn
nut (N) against the arm to secure the position.
Image 7-3
Assemble swivel arm
2. Slide a washer (M) over the base of the swivel arm and Insert the base of the swivel arm into the mounting hole at the top of the
DP2K C-series projectoras illustrated.
Image 7-4
Mount swivel arm
54
:
For more information about the use of the Communicator Touch Panel, consult its user guide.
N
L
M
R5905050 DP2K C-SERIES 10/07/2012