Removal Of The Input Cover - Barco DP2K-12C Installation Manual

10. Removal and installation of projector covers
2. Remove the lamp cover from the projector doing the following:
a) gently pull out the left bottom corner (A) of the lamp cover,
b) then gently pull out the left top corner (B) of the lamp cover,
c) then move the lamp cover away from the projector (C).
B
A
Image 10-2
Remove lamp cover

10.2 Removal of the input cover

W
ARNING
Necessary tools
Flat screw driver.
How to remove the input cover of the projector?
1. Release the two captive screws at the top and bottom left side of the input cover, using a flat screw driver.
Image 10-3
Release input cover
2. Remove the input cover from the projector doing the following:
a) gently pull out the right bottom corner (A) of the input cover,
b) then gently pull out the right top corner (B) of the input cover,
c) then move the input cover away from the projector (C).
68
:
This procedure may only be performed by qualified technical service personnel.
C
R5905050 DP2K C-SERIES 10/07/2012