Prestige 861H User's Guide
2.3
Rear Panel
2.3.1 VDSL Port
Connect the Prestige directly to the wall jack using a telephone wire (RJ-11 connector).
2.3.2 LAN 10/100M
The Prestige has four 10/100Mbps auto-negotiating, auto-crossover Ethernet ports. The LAN interface
is auto-crossover, so you may use a crossover cable or a straight-through Ethernet cable to connect
your Prestige to a computer/external hub.
2.3.3 Console Port
You can configure the Prestige via a terminal emulator software on a computer that is connected to the
Prestige through the console port. Connect the male end of the console cable to the console port of the
Prestige and the female end to a serial port (COM1, COM2 or other COM port) of your computer.
2.3.4 Power Port
Connect the power adaptor to the port labeled POWER on the rear panel of your Prestige. Push in the
power button to turn on the Prestige.
To avoid damage to the Prestige, make sure you use the
supplied power adaptor.
2.4
Turning On Your Prestige
You can now turn on your Prestige by pushing in the power button (located on the back panel).
2-2
Figure 2-2 Rear Panel
Hardware Installation