Ftp File Upload Command From The Dos Prompt Example; Ftp Session Example Of Firmware File Upload; Tftp File Upload; Figure 26-7 Ftp Session Example Of Firmware File Upload - ZyXEL Communications Prestige 861H-G1 User Manual

To upload the firmware and the configuration file, follow these examples

26.4.3 FTP File Upload Command from the DOS Prompt Example

Launch the FTP client on your computer.
1.
Enter "open", followed by a space and the IP address of your Prestige.
2.
Press [ENTER] when prompted for a username.
3.
Enter your password as requested (the default is "1234").
4.
Enter "bin" to set transfer mode to binary.
5.
Use "put" to transfer files from the computer to the Prestige, for example, "put firmware.bin
6.
ras" transfers the firmware on your computer (firmware.bin) to the Prestige and renames it
"ras". Similarly, "put config.rom rom-0" transfers the configuration file on your computer
(config.rom) to the Prestige and renames it "rom-0". Likewise "get rom-0 config.rom"
transfers the configuration file on the Prestige to your computer and renames it "config.rom."
See earlier in this chapter for more information on filename conventions.
Enter "quit" to exit the ftp prompt.
7.
The Prestige automatically restarts after a successful file upload.

26.4.4 FTP Session Example of Firmware File Upload

331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put firmware.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 1103936 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit

Figure 26-7 FTP Session Example of Firmware File Upload

More commands (found in GUI-based FTP clients) are listed earlier in this chapter.
Refer to section 26.2.5 to read about configurations that disallow TFTP and FTP over WAN.

26.4.5 TFTP File Upload

The Prestige also supports the uploading of firmware files using TFTP (Trivial File Transfer
Protocol) over LAN. Although TFTP should work over WAN as well, it is not recommended.
To use TFTP, your computer must have both telnet and TFTP clients. To transfer the firmware
and the configuration file, follow the procedure shown next.
Firmware and Configuration File Maintenance
Prestige 861H User's Guide
26-9