Prestige 861H User's Guide
TELNET Server:
Server Port = 23
Secured Client IP = 0.0.0.0
FTP Server:
Server Port = 21
Secured Client IP = 0.0.0.0
Web Server:
Server Port = 80
Secured Client IP = 0.0.0.0
Figure 28-1 Menu 24.11 Remote Management Control
The following table describes the fields in this menu.
Table 28-1 Menu 24.11 Remote Management Control
FIELD
Telnet Server
Each of these read-only labels denotes a service or protocol.
FTP Server
Web Server
Port
This field shows the port number for the service or protocol. You
may change the port number if needed, but you must use the same
port number to access the Prestige.
Access
Select the access interface (if any) by pressing the [SPACE BAR].
Choices are: LAN only, WAN only, All or Disable. The default is
All.
Secured Client IP
The default 0.0.0.0 allows any client to use this service or protocol
to access the Prestige. Enter an IP address to restrict access to a
client with a matching IP address.
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.
28.2.2 Remote Management Limitations
Remote management over LAN or WAN will not work when:
A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or
1.
Web service.
You have disabled that service in menu 24.11.
2.
The IP address in the Secured Client IP field (menu 24.11) does not match the client IP
3.
address. If it does not match, the Prestige will disconnect the session immediately.
There is already another remote management session with an equal or higher priority
4.
running. You may only have one remote management session running at one time.
There is a filter rule that blocks it.
5.
28-2
Menu 24.11 - Remote Management Control
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Server Access = All
Server Access = All
Server Access = All
Remote Management
EXAMPLE
23
All
0.0.0.0