Bridge Static Route Setup; Figure 21-2 Menu 11.3 Remote Node Network Layer Options; Table 21-1 Remote Node Network Layer Options: Bridge Fields - ZyXEL Communications Prestige 861H-G1 User Manual

Prestige 861H User's Guide
IP Options: N/A
IP Address Assignment = N/A Ethernet Addr Timeout(min)= 0
Rem IP Addr = N/A
Rem Subnet Mask= N/A
My WAN Addr= N/A
NAT= Full Feature
Address Mapping Set= N/A
Metric= N/A
Private= N/A
RIP Direction= N/A
Version= N/A
Multicast= N/A
IP Policies=

Figure 21-2 Menu 11.3 Remote Node Network Layer Options

Table 21-1 Remote Node Network Layer Options: Bridge Fields

FIELD
Bridge (menu 11.1)
Edit IP/Bridge (menu
11.1)
Ethernet Addr
Timeout
(min.) (menu 11.3)
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.

21.5.2 Bridge Static Route Setup

Similar to network layer static routes, a bridging static route tells the Prestige the route to a node
before a connection is established. You configure bridge static routes in menu 12.3.1 (go to menu
12, choose option 3, then choose a static route to edit) as shown next.
21-4
Menu 11.3 - Remote Node Network Layer Options
Enter here to CONFIRM or ESC to CANCEL:
Make sure this field is set to Yes.
Press [SPACE BAR] to select Yes and press [ENTER] to display menu 11.3.
Type the time (in minutes) for the Prestige to retain the Ethernet Address
information in its internal tables while the line is down. If this information is
retained, your Prestige will not have to recompile the tables when the line comes
back up.
Bridge Options:
DESCRIPTION
Bridging Setup