IP Alias 1= Yes
IP Address= 192.168.2.1
IP Subnet Mask= 255.255.255.0
RIP Direction= None
Version= RIP-1
Incoming protocol filters=
Outgoing protocol filters=
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Follow the instructions in the following table to configure IP Alias parameters.
FIELD
IP Alias
Choose Yes to configure the LAN network for the Prestige.
IP Address
Enter the IP address of your Prestige in dotted decimal notation
IP Subnet Mask Your Prestige will automatically calculate the subnet mask based on the
IP address that you assign. Unless you are implementing subnetting,
use the subnet mask computed by the Prestige
RIP Direction
Press [SPACE BAR] to select the RIP direction. Choices are None,
Both, In Only or Out Only.
Version
Press [SPACE BAR] to select the RIP version. Choices are RIP-1, RIP-
2B or RIP-2M.
Incoming
Enter the filter set(s) you wish to apply to the incoming traffic between
Protocol Filters
this node and the Prestige.
Outgoing
Enter the filter set(s) you wish to apply to the outgoing traffic between
Protocol Filters
this node and the Prestige.
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to save
your configuration, or press [ESC] at any time to cancel.
18.9 Route IP Setup
The first step is to enable the IP routing in Menu 1 — General Setup.
To edit menu 1, type 1 in the main menu and press [ENTER]. Set the Route IP field to Yes by
pressing [SPACE BAR].
Internet Access
Menu 3.2.1 - IP Alias Setup
Figure 18-5 Menu 3.2.1 IP Alias Setup
Table 18-1 Menu 3.2.1 IP Alias Setup
DESCRIPTION
Prestige 861H User's Guide
EXAMPLE
Yes
192.168.2.1
255.255.255.0
None
RIP-1
18-5