Remote Management Limitations; Remote Management And Nat; System Timeout - ZyXEL Communications P-320W v3 User Manual

Chapter 15 Remote Management
15.2 What You Can Do
• Use the WWW screen
World Wide Web settings.
• Use the SNMP screen
administrate your P-320W v3 over the network.
• Use the Security screen
320W v3 responds to ping from WAN.
15.3 What You Need to Know
The following sections provide helpful information needed to configure the screens
in this chapter.

15.3.1 Remote Management Limitations

Remote management over LAN or LAN and WAN will not work when:
You have disabled that service in one of the remote management screens.
1
The IP address in the Secured Client IP Address field
2
137) does not match the client IP address. If it does not match, the P-320W v3
will disconnect the session immediately.
There is already another remote management session with an equal or higher
3
priority running. You may only have one remote management session running at
one time.
4 There is a firewall rule that blocks it.

15.3.2 Remote Management and NAT

When NAT is enabled:
• Use the P-320W v3's WAN IP address when configuring from the WAN.
• Use the P-320W v3's LAN IP address when configuring from the LAN.

15.3.3 System Timeout

There is a default system management idle timeout of five minutes (three
hundred seconds). The P-320W v3 automatically logs you out if the management
session remains idle for longer than this timeout period. The management session
136
(Section 15.4 on page
(Section 15.5 on page
(Section 15.6 on page
137) to change your P-320W v3's
138) to have a manager station
139) to configure how your P-
(Section 15.4 on page
P-320W v3 User's Guide