Chapter 13 Remote Management
13.1.1 Remote Management Limitations
Remote management over LAN or WAN will not work when:
You have disabled that service in one of the remote management screens.
1
The IP address in the Secured Client WAN IP Address field does not match the client IP address.
2
If it does not match, the NBG-418N will disconnect the session immediately.
There is already another remote management session with an equal or higher priority running. You
3
may only have one remote management session running at one time.
There is a firewall rule that blocks it.
4
13.1.2 Remote Management and NAT
When NAT is enabled:
• Use the NBG-418N's WAN IP address when configuring from the WAN.
• Use the NBG-418N's LAN IP address when configuring from the LAN.
13.1.3 System Timeout
There is a default system management idle timeout of five minutes (three hundred seconds). The
NBG-418N automatically logs you out if the management session remains idle for longer than this
timeout period. The management session does not time out when a statistics screen is polling. You
can change the timeout period in the System screen.
13.2 WWW Screen
To change your NBG-418N's World Wide Web settings, click Management > Remote MGMT to
display the WWW screen.
Figure 81 Management > Remote MGMT > WWW
116