Remote Node Setup; Figure 4-3 Remote Node Network Layer Options; Table 4-2 Remote Node Network Layer Options - ZyXEL Communications P650HW User Manual

4.2

Remote Node Setup

For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network
Layer Options as shown next.
Step 1. In menu 11.1, make sure IP is among the protocols in the Route field.
Step 2. Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes, then press
[ENTER] to display Menu 11.3 – Remote Node Network Layer Options.
IP Options:
Press ENTER to Confirm or ESC to Cancel:
The next table explains fields in Menu 11.3
FIELD
IP Address Press [SPACE BAR] and then [ENTER] to select Dynamic if the remote
node is using a dynamically assigned IP address or Static if it is using a
Assignment
static (fixed) IP address. You will only be able to configure this in the
ISP node (also the one you configure in menu 4), all other nodes are
set to Static.
Rem IP Addr This is the IP address you entered in the previous menu.
Rem Subnet Type the subnet mask assigned to the remote node.
Mask
Remote Node Configuration
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Static
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= Full Feature
Address Mapping Set= 2
Metric= 2
Private= No
RIP Direction= None
Version= None
Multicast= None
IP Policies= 3,4,5,6
Rem Node Name= myISP

Figure 4-3 Remote Node Network Layer Options

Table 4-2 Remote Node Network Layer Options

Bridge Options:
Ethernet Addr Timeout (min)= 0
Route= IP
Remote Node Network Layer Options.
–
DESCRIPTITON
Prestige 650HW ADSL Router
EXAMPLE
Static
4-7