Remote Node Setup; Figure 4-3 Remote Node Network Layer Options; Table 4-2 Remote Node Network Layer Options - ZyXEL Communications Prestige 650ME User Manual

Prestige 650ME ADSL Bridge
4.2

Remote Node Setup

For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network
Layer Options as shown next.
Step 1. In menu 11.1, make sure IP is among the protocols in the Route field.
Step 2. Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes, then press
[ENTER] to display Menu 11.3 – Remote Node Network Layer Options.
IP Options:
The next table explains fields in Menu 11.3
FIELD
IP Address
Assignment
Rem IP Addr
Rem Subnet Mask
4-6
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Static
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
IP Policies= 3,4,5,6
Press ENTER to Confirm or ESC to Cancel:

Figure 4-3 Remote Node Network Layer Options

Table 4-2 Remote Node Network Layer Options

Press [SPACE BAR] and then [ENTER] to select Dynamic if the
remote node is using a dynamically assigned IP address or Static if it
is using a static (fixed) IP address. You will only be able to configure
this in the ISP node (also the one you configure in menu 4), all other
nodes are set to Static.
This is the IP address you entered in the previous menu.
Type the subnet mask assigned to the remote node.
Bridge Options:
Ethernet Addr Timeout(min)= 0
Remote Node Network Layer Options.
–
DESCRIPTION EXAMPLE
Static
Remote Node Configuration