Clutch-Side Crankcase Half Component Disassembly - Husqvarna CR 125 2011 Workshop Manual

CR 125 2011 - WR 125 2011
1
4
13
ENGINE DISASSEMBLY

Clutch-side crankcase half component disassembly

Working crossways, loosen the five retaining screws (1) on clutch springs, and
remove them together with the relevant washers (2) and springs (3).
H06793
Remove pressure plate (4) and clutch plates pack (5) from hub.
Slide thrust washer (6), axial roller bearing (7) and retainer (8) out of primary
shaft end. Tilt engine block on the right side, and slide out ball (9) and pushrod
(10).
Working on the opposite side, slide out clutch control lever (11) together with
return spring and bushing.
H06794
Using a chisel and a hammer, straighten the bent sections of lock washer (12)
on clutch hub sealing nut (13).
12
H06795
F.5
Workshop Manual Ed. 06-2011