Husqvarna CR 125 2011 Workshop Manual page 160

Workshop Manual Ed. 06-2011
FRONT SUSPENSION
CR 125 2011 - WR 125 2011
Pull the piston rod until fully extended.
Check oil level. It should be about 145 mm (5.7 in.).
H06843
Push the piston rod all the way down and install the bottom valve assembly.
With the bottom valve assembly installed, check that the piston rod is fully
extended.
H06844
Hold the cartridge octagonal nut to prevent rotation.
Use a similar tool in the octagonal recess of the bottom valve assembly.
Tighten the bottom valve assembly to 29 Nm (21.4 ft/lb) using a wrench.
H06845
Hold the cartridge with the piston rod end pointing downwards as shown in the
figure.
Pump the piston rod up and down a dozen times to help oil reach all points of
the unit.
H06847
I.12