Piston-Cylinder-And-Head Reassembly - Husqvarna CR 125 2011 Workshop Manual

H06968
2
Workshop Manual Ed. 06-2011
ENGINE ASSEMBLY
CR 125 2011 - WR 125 2011
Fit the spacer (9) and the tab in the crankshaft seat, and install the primary drive
8
gear (7) and the water pump control gear (8).
7
9

Piston-cylinder-and-head reassembly

Fit the roller cage on connecting rod small end, and position cylinder bottom
seal (1).
Install the piston with its rings inside the connecting rod, taking care that the
arrow on the crown is pointing the exhaust. Push the lubricated piston pin (2)
1
into the piston by hand, and lock it in place with its clips.
H06610
Lubricate all the parts to be assembled with engine oil and fit the cylinder into
the piston by compressing the ends of the piston rings with your fingers (or us-
ing a universal piston installation tool).
H06611
During installation, avoid rotating the cylinder since piston ring
ends could enter ducts.
H.10