Husqvarna CR 125 2011 Workshop Manual page 137

2
1
2
3
3
1
2
ENGINE ASSEMBLY
CR 125 2011 - WR 125 2011
Fit the selector shaft with its bearing and sector gear well lubricated with engine
oil in the right half crankcase. If the ratchet is already assembled on the outer
side of the crankcase half, use pliers to counteract the action of the spring so
as to allow the insertion of the selector shaft.
H06960
Fit the gearbox forks into their seats on the sliding gears; Engage the forks
control pins into the selector shaft grooves. This operation is easier if the gear
is in "neutral". Assemble the well lubricated fork sliding pins into their seats in
the right crankcase half: both have the same length. Fit the original shim (1)
on primary shaft end.
1
H06603
Check the position of the centring bushings and place a new gasket on the
right crankcase half. Close the crankcase halves with the suitable retaining
screws, see relevant diagram.
1
4 1 - M6X35 screw - No. 5 pieces.
2 - M6X45 screw - No. 3 pieces.
3 - M6X50 screw - No. 2 pieces.
4 - M6X65 screw - No. 2 pieces.
4
1
1
H06604
H.7
Workshop Manual Ed. 06-2011