Changing The Fluid - Husqvarna CR 125 2011 Workshop Manual

1A
Workshop Manual Ed. 06-2011
BRAKES
CR 125 2011 - WR 125 2011

Changing the fluid

Brake fluid should be checked and changed as per the "Maintenance Chart"
(see Section B), or earlier if contaminated with debris or water.
Do not change brake fluid in the rain or with a strong wind.
Use only fluid (of the specified type) taken from a sealed container.
Never reuse brake fluid.
Avoid the ingress of contaminants such as dirt, water, etc. into the
reservoir.
Do not keep the reservoir open without its cover longer than neces-
sary; this would increase the risk of contamination.
Handle the fluid with care to avoid damage to painted parts.
Do not mix two brands of fluid. This would reduce boil-over point,
leading to loss of braking efficiency or degrading of rubber parts.
Replacement procedure is as follows:
1) Take the rubber cap off the bleed valve (1) or (1A).
2) Attach a clear plastic hose to the calliper bleed valve and place the other
end of the hose in a vessel (make sure the hose end stays dipped in the fluid
throughout the procedure).
H02297
L.8