Handlebar; Removing The Handlebar; Checking The Handlebar; Installing The Handlebar - Yamaha Grizzly550 User Manual

EAS22860

REMOVING THE HANDLEBAR

1. Place the vehicle on a level surface.
2. Remove:
• Handlebar grip "1"
TIP
Blow compressed air between the left handlebar
end and the handlebar grip, and gradually push
the grip off the handlebar.
EAS22880

CHECKING THE HANDLEBAR

1. Check:

• Handlebar

Bends/cracks/damage → Replace.
EWA13690
WARNING
Do not attempt to straighten a bent handle-
bar as this may dangerously weaken it.
EAS22940

INSTALLING THE HANDLEBAR

1. Place the vehicle on a level surface.
2. Install:
• Handlebar
• Handlebar holders
Handlebar holder bolt
20 Nm (2.0 m·kg, 14 ft·lb)
TIP
• Install the handlebar within 15° from the hori-
zontal line shown in the illustration.
• The upper handlebar holders should be in-
stalled with the punch mark "a" forward "A".
• First tighten the bolts "1" on the front side of the
handlebar holders, and then tighten the bolts
"2" on the rear side.
3. Install:
• Handlebar grip "1"
M MMM M MMM M M MMM M
a. Wipe off grease or oil on the handlebar sur-
face "a" with a lacquer thinner.
b. Apply a thin coat of rubber adhesive onto the
left and right ends of the handlebar.
c. Install the handlebar grips to the handlebar so
that arrow mark "L" faces up on the left han-
dlebar grip and the arrow mark "R" faces up
on the right handlebar.
d. Wipe off any excess rubber adhesive with a
clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
4-46
HANDLEBAR
M MMM M M MMM M M MMM M MMM
techsparkstudio.com