Checking The Lean Angle Sensor; Checking The Starter Motor Operation; Checking The Stator Coil - Yamaha Grizzly550 User Manual

Atv
Table of Contents

Advertisement

Gy
1
b. Measure the crankshaft position sensor re-
sistance.
L
LLL
L LLL
L
L LLL
L
L LLL
L
EAS28130

CHECKING THE LEAN ANGLE SENSOR

1. Remove:
• Lean angle sensor
2. Check:
• Lean angle sensor output voltage
Out of specification → Replace.
Lean angle sensor output voltage
Less than 65°: 3.55–4.45 V
More than 65°: 0.65–1.35 V
M
MMM
M MMM
M
M MMM
M
M MMM
M
a. Connect the lean angle sensor coupler to the
wire harness.
b. Connect the pocket tester (DC 20 V) to the
lean angle sensor coupler as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe
yellow/green "1"
• Negative tester probe
black/blue "2"
65˚
65˚
UP
c. Set the main switch to "ON".
d. Tilt the lean angle sensor to 65°.
B
2
L LLL
L
L LLL
L
LLL
M MMM
M
M MMM
M
MMM
L Y/G B/L
1
2
9-92
ELECTRICAL COMPONENTS
e. Measure the lean angle sensor output volt-
age.
L
LLL
L LLL
L
L LLL
L
L LLL
L
EAS28940
CHECKING THE STARTER MOTOR
OPERATION
1. Check:
• Starter motor operation
Does not operate → Perform the electric
starting system troubleshooting, starting with
step 4.
Refer to "TROUBLESHOOTING" on page
9-9.
M
MMM
M MMM
M
M MMM
M
M MMM
M
a. Connect the positive battery terminal "1" and
starter motor lead "2" with a jumper lead "3".
EWA13810
WARNING
• A wire that is used as a jumper lead must
have at least the same capacity of the bat-
tery lead, otherwise the jumper lead may
burn.
• This check is likely to produce sparks,
therefore, make sure no flammable gas or
fluid is in the vicinity.
Br/B
R/W
L/Y
R/Y
b. Check the starter motor operation.
L
LLL
L LLL
L
L LLL
L
L LLL
L
EAS28150

CHECKING THE STATOR COIL

1. Disconnect:
• AC magneto coupler
(from the wire harness)
2. Check:
• Stator coil resistance
Out of specification → Replace the crank-
shaft position sensor/stator assembly.
Stator coil resistance
0.108–0.132 Ω at 20 °C (68 °F)
M
MMM
M MMM
M
M MMM
M
M MMM
M
a. Connect the pocket tester (Ω × 1) to the AC
magneto coupler as shown.
L LLL
L
L LLL
L
LLL
M MMM
M
M MMM
M
MMM
L LLL
L
L LLL
L
LLL
M MMM
M
M MMM
M
MMM
techsparkstudio.com

Advertisement

Table of Contents
loading

This manual is also suitable for:

Grizzly700

Table of Contents