Checking The Final Gear Oil Level - Yamaha Grizzly550 User Manual

M MMM M MMM M M MMM M M MMM M
Drive select lever shift control cable:
a. Make sure that the drive select lever is in "N"
(neutral).
b. Squeeze the brake lever 20 mm (0.79 in) "a",
loosen the locknut "1", and then adjust the
shift control cable "2" with the adjuster "3" so
that the drive select lever can be shifted to "R"
(reverse) from "N" (neutral), and to "P" (park)
from "R" (reverse).
a
2
1
3
c. Release the brake lever so that "a" is 0 mm (0
in), and then verify that the drive select lever
cannot be shifted to "R" (reverse) from "N"
(neutral), or to "P" (park) from "R" (reverse).
d. If the operation of the drive select lever is in-
correct, repeat steps (a) to (c).
e. Tighten the locknut.
L LLL L LLL L L LLL L L LLL L
M MMM M MMM M M MMM M M MMM M
Drive select lever shift rod:
a. Make sure the drive select lever and trans-
mission are in "N" (neutral).
b. Loosen both locknuts "1".
c. Adjust the length "a" of the shift rod to 413
mm (16.3 in).
M MMM M M MMM M MMM
L LLL L L LLL L LLL
M MMM M M MMM M MMM
3-25
N
1
d. Tighten the locknuts.
Drive select lever shift rod lock-
nut
7 Nm (0.7 m·kg, 5.1 ft·lb)
e. Start the engine, and then check that the
drive select lever can be shifted to each shift
position and that the appropriate indicator
light comes on when the lever is in each po-
sition.
TIP
If the neutral indicator light does not come on
when the drive select lever is in the "N" (neutral)
position, stop the engine. Then, with the drive
select lever in the "N" (neutral) position and with-
out opening the throttle, start the engine and
check that the neutral indicator light comes on.
f. Adjust the shift control cable again if neces-
sary.
L LLL L LLL L L LLL L L LLL L
EAS21460

CHECKING THE FINAL GEAR OIL LEVEL

1. Place the vehicle on a level surface.
2. Remove:
• Final gear oil level check bolt "1"
3. Check:
• Final gear oil level
The final gear oil level should be up to the
brim "2" of the hole.
Below the brim → Add the recommended fi-
nal gear oil to the proper level.
Type
SAE 80 API GL-4 Hypoid gear
oil
ECA28P1005
NOTICE
Take care not to allow foreign material to en-
ter the final drive case.
CHASSIS
a
N
L LLL L L LLL L LLL