Yamaha Grizzly550 User Manual page 98

b. Loosen the water pump air bleed bolt "2",
without removing it, to allow all of the air to es-
cape from the air bleed bolt hole.
c. When coolant begins to flow out of the bolt
hole, tighten the water pump air bleed bolt to
specification.
Water pump air bleed bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
d. Loosen the cylinder head air bleed bolt "3",
without removing it, to allow all of the air to es-
cape from the air bleed bolt hole.
3
e. When coolant begins to flow out of the bolt
hole, tighten the cylinder head air bleed bolt
to specification.
Cylinder head air bleed bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
f. Install the V-belt cooling exhaust duct.
L LLL L LLL L L LLL L L LLL L
1
2
L LLL L L LLL L LLL
3-19
15.Start the engine, warm it up for ten minutes,
and then rev the engine five times.
16.Pour the recommended coolant into the radi-
ator until it is full.
17.Stop the engine and allow it to cool. If the
coolant level has dropped after the engine
has cooled, add sufficient coolant until it
reaches the top of the radiator, and then in-
stall the radiator cap.
18.Start the engine, and then check for coolant
leakage.
• Coolant level
Refer to "CHECKING THE COOLANT LEV-
EL" on page 3-16.
19.Install:
• Upper panel
• Front carrier
• Left side panel
• Right side panel
Refer to "GENERAL CHASSIS" on page 4-1.
ENGINE