Instrument Functions - Yamaha Grizzly550 User Manual

EAS28P1035

INSTRUMENT FUNCTIONS

Multifunction display
3
2
1
7
1. "CLOCK" button
2. "RESET" button
3. "SELECT" button
4. Speedometer
5. Fuel meter
6. Clock/Hour meter
7. Odometer/Tripmeter A/Tripmeter B
The multifunction display is equipped with the
following:
• a speedometer (which shows the riding speed)
• an odometer (which shows the total distance
traveled)
• two tripmeters (which show the distance trav-
eled since they were last set to zero)
• a clock
• an hour meter (which shows the total time the
engine has been running)
• a fuel meter
• a self-diagnosis device
Odometer and tripmeter modes
Pushing the "SELECT" button switches the dis-
play between the odometer mode "ODO" and
the tripmeter modes "A" and "B" in the following
order:
ODO → TRIP A → TRIP B → ODO
To reset a tripmeter, select it by pushing the "SE-
LECT" button, and then push the "RESET" but-
ton for at least three seconds. The tripmeters
can be used to estimate the distance that can be
traveled with a full tank of fuel. This information
will enable you to plan future fuel stops.
TIP
Pushing and holding in the "SELECT" button,
and turning the key to "ON" while the button is
pushed, switches the display between "mph"
and "km/h".
4 5
6
1-9
Clock mode
Pushing the "CLOCK" button switches the dis-
play between the clock mode "CLOCK" and the
hour meter mode "HOUR" in the following order:
CLOCK → HOUR → CLOCK
To set the clock:
1. Set the display to the clock mode.
2. Push the "SELECT" button and "RESET" but-
ton together for at least three seconds.
3. When the hour digits start flashing, push the
"RESET" button to set the hours.
4. Push the "SELECT" button, and the minute
digits will start flashing.
5. Push the "RESET" button to set the minutes.
6. Push the "SELECT" button and then release
it to start the clock.
Fuel meter
1. Fuel level warning indicator
2. Fuel meter
3. "E" segment
The fuel meter indicates the amount of fuel in the
fuel tank. The display segments of the fuel meter
disappear from "F" (full) towards "E" (empty) as
the fuel level decreases. When the "E" segment
disappears and the fuel level warning indicator
flashes, refuel as soon as possible.
TIP
This fuel meter is equipped with a self-diagnosis
system. If the electrical circuit is defective, all the
display segments and fuel level warning indica-
tor will start flashing. If this occurs, check the
electrical circuit.
Refer to "SIGNALING SYSTEM" on page 9-19.
FEATURES
1
2
3