Yamaha Grizzly550 User Manual page 71

1. Left headlight lead
2. Four-wheel-drive motor relay 1
3. Four-wheel-drive motor relay 2
4. Headlight relay
5. Battery
6. ECU (engine control unit)
7. Negative battery lead
8. Right headlight lead
9. EPS (electric power steering) control unit
(YFM5FGP/YFM7FGP only)
10. Radiator fan motor lead
11. EPS control unit lead (YFM5FGP/YFM7FGP only)
12. Auxiliary DC jack lead
13. Main switch lead
14. Radiator fan motor relay
15. Fuel injection system relay
16. Four-wheel-drive motor relay 3
17. Final drive case breather hose
18. Starter motor lead
19. Differential motor lead
20. Meter assembly lead
21. Lean angle sensor lead
22. Coolant reservoir breather hose
23. Fuse box
24. Spare fuse
25. Main fuse
26. EPS fuse (YFM5FGP/YFM7FGP only)
27. Starter relay
28. Positive battery lead
29. Ground lead
30. Coolant reservoir hose
31. EPS motor breather hose (YFM5FGP/YFM7FGP
only)
32. Differential case breather hose
33. Radiator fan motor breather hose
34. Wire harness
A. To left headlight
B. Connect the headlight coupler, and then fasten the
coupler with the holder on the electrical
components tray.
C. To right headlight
D. Route the negative battery lead along the guide on
the electrical components tray.
E. Place the couplers on the inside of the electrical
components tray.
F. To main switch and auxiliary DC jack
G. Route the starter motor lead above the leads in the
electrical components tray.
H. Fasten the EPS control unit lead with the holder.
(YFM5FGP/YFM7FGP only)
I. Fasten the meter assembly lead and EPS control
unit lead (YFM5FGP/YFM7FGP only) with the twist
tie.
J. Fasten the left handlebar switch lead, on-
command four-wheel-drive motor switch and
differential gear lock switch lead, front brake light
switch lead, and rear brake light switch lead with
the holder.
K. Fasten the joint coupler lead with the holder.
L. Pass the coolant reservoir breather hose through
the guides on the plastic cover and electrical
components tray and route it under the positive
battery lead and starter motor lead.
M. Route the hoses under the positive battery lead,
and then route them upward, to the inside of the
coolant reservoir breather hose.
N. Fasten the coolant reservoir breather hose with the
holder on the electrical components tray.
O. Fasten the coolant reservoir hose with the holder
on the electrical components tray.
P. Pass the hoses and ground lead through the
opening in the electrical components tray.
Q. Route the coolant reservoir breather hose above
the other hoses.
R. Route the hoses to the inside of the screw.
2-42
CABLE ROUTING
techsparkstudio.com