Fuel Piping Switch (3Way Fuel Valve) - Shindaiwa DGK45F Owner's And Operator's Manual

< Note >
 If measuring the output current for a single-phase three-wire type, turn the ammeter selector
switch to "L1+U" or "L3+W". The voltage cannot be accurately measured if set to "L2".
Voltage Regulator/Throttle Switch
(1) Voltage Regulator
This dial is for regulating voltage output by the generator. Turn the
dial clockwise to increase the voltage and counterclockwise to
decrease it.
(2) Throttle Switch
This switch is for changing the engine speed. Set to IDLING when starting,
warming up and cool down the engine, and set to RUN during rated operation.

5-7. Fuel Piping Switch (3Way Fuel Valve)

CAUTION:
 Always make sure that the engine is stopped when working on piping.
 Always be sure to wipe up any spilled fuel.
 After working on the piping, check that there is no fuel leakage.
Change the three-way fuel valve to switch to supply fuel from the external tank. In that case,
the internal fuel tank will not be used.
(1) If using the internal fuel tank
Change the lever of the three-way fuel valve is turned to the "B" side to supply fuel from
the internal tank. It is turned to the "B" side when the generator is shipped from the
factory.
< Note >
 When disconnecting piping from the external tank, turn the lever to the "B" side, and attach the
bundled plug (R1/2") to the external tank fuel inlet/return.
(2) If using an external fuel tank
Connect hoses from the external fuel tank to the external fuel inlet and the external fuel
return. Change the lever of the 3way fuel valve to the "A" side to supply fuel from the
external tank.
Refer to "9-6. Connecting with External Fuel Tank" for corresponding procedures.
External Fuel
Return
External Fuel
Inlet
3Way Fuel
Valve
17
Voltage Regulator
Throttle Switch
Position A Position B