Table of Contents
Advertisement
(2) Circuit Breaker
This switch is for transmitting electrical power to the load side. Turn to ON position to
output voltage to the output terminals. Output to the load side is cut off when there is a
short circuit or overload on the load side.
(3) 3-Phase Earth Leakage Relay
When current leak occurs, it trips to stop power transmission to load.
< Note >
Do not use this relay as the ON/OFF switch to the load.
Voltage Regulator
(1) Voltage Regulator
This dial is for regulating voltage output by the generator.Turn the dial clockwise to
increase the voltage and counterclockwise to decrease it.
5-4. Frequency change
CAUTION : PROPERTY DAMAGE
When changing the frequency, be sure to adjust the Frequency adjusut screw
and change the Controller settings.
Turn the Power Switch to ON position.
1
Press the Stop Mode Button and "
2
display.
Press the " " button or the " " button to select the Alt Config.
3
Press the " " button or the "
4
the "
Press the " " button or the "
5
"
" button.
Press and hold the "
6
< Note >
Check that no loads are connected before using the frequency selector switch.
Be sure to select "50Hz 400V" or "60Hz 440V". Contact distributor if you want to use
"50Hz 200V" or "60Hz 220V".
This switch is set to 50Hz when shipped from the factory.
5-5. Fuel Piping Switch (3Way Fuel Valve)
CAUTION : FIRE
Always make sure that the Power Switch is OFF position when working on
piping.
Always be sure to wipe up any spilled fuel.
After working on the piping, check that there is no fuel leakage.
Change the 3way fuel valve to switch to supply fuel from the external tank. In that case,
the internal fuel tank is not used.
(1) If using the internal fuel tank
The 3way fuel valve is turned to the "A" side when the generator is shipped from the
factory.
" button.
" button to save settings.
" button together to enter the editor
" button to select the Default Config and press
" button to change frequency and press the
17
Advertisement
Table of Contents
