Table of Contents
Advertisement
VISTA-50P/VISTA-50PUL Installation and Setup Guide
RF System Installation Advisories
•
Place the receiver in a high, centrally located area.
Do not place it on or near metal objects. This will
decrease the range and/or block transmissions.
•
Install the RF receiver at least 10 feet from the
control panel or any keypads, to avoid interference
from the microprocessors in these units.
•
If dual receivers are used:
a.
They must be at least 10 feet from each other,
as well as from the control panel and remote
keypads.
b.
Each receiver must be set to a different device
address. The receiver set to the lower address
is considered the 1st RF receiver for
supervisory purposes.
c.
The House IDs must be the same.
d.
Using two receivers does not increase the
number of transmitters the system can support
(85 zones using the 5881H, plus a wireless
keypad).
Installation and Setup of the 5881 RF Receivers
Take note of the address you select for the RF
receiver, as this address must be enabled in
the system's Device Programming in the #93
Menu Mode.
Figure 3-19: Installing the 5881ENHC with Tamper
Protection
3-14
SCREW
5881ENHC-001-V0
WWW.DIYALARMFORUM.COM
To install the 5881 RF receiver, perform the following
steps:
Step
Action
1
Mount the receiver, following the advisories
stated previously.
2
Set the DIP switches in the receiver for the
address (01-07). See Figure 3-20.
Make sure the address setting is not
being used by another device (keypad,
relay module, etc.).
3
If installing a 5881ENHC, install a flat-head
screw (supplied) in the case tamper tab as
shown in Figure 3-19. When the receiver is
pried from the wall, the tamper tab will break
off and remain on the wall. This will activate
a tamper switch in the receiver and cause
generation of a tamper signal. Note that this
signal will also be generated when the
receiver's front cover is removed.
4
Connect the receiver's wire harness to the
keypad terminals (6, 7, 8, and 9). Plug the
connector at the other end of the harness into
the receiver.
5
Refer to the Installation Instructions
provided with the receiver for installations
regarding antenna mounting, etc.
Advertisement
Table of Contents
