Table of Contents
Advertisement
Supervising the Alarm Output
To wire the alarm output using the supervision feature,
perform the following steps:
Step
Action
1
Wire polarized fire-indicating devices to the
alarm output as shown in Figure 3-6.
2
Wire nonpolarized burglary indicating
devices to the alarm output using a polarizing
diode (two 2A diodes supplied), as shown in
Figure 3-7.
3
Program Zone 98 with a response type of 05
(trouble by day/alarm by night).
The minimum load on the alarm output must
exceed 5mA at 12V for proper supervision
operation.
1
2
3
+
ALARM SOUNDER OUTPUT:
1-VDC - 13.8VDC
1.7A MAXIMUM
Figure 3-6: Wiring Polarized Fire Devices
POLARIZING DIODES
(MUST MOUNT AT INDICATING DEVICE)
PANEL BELL
BELL
PANEL BELL
NONPOLARIZED BURGLARY
INDICATING DEVICES
Figure 3-7: Wiring Nonpolarized Burglary Devices
WWW.DIYALARMFORUM.COM
4
5
6
7
8
-
+
-
BELL
HORN
HORN
BELL
POLARIZED FIRE
INDICATING DEVICE
Using a Siren Driver
To install a siren driver, perform the following steps:
Step
Action
1
Mount the siren driver in the panel's cabinet.
2
Wire the siren driver to the control and to the
speaker(s). (See the driver's instructions.)
3
Cut the blue jumper on the upper left-hand
corner of the panel's PC board.
4
Program Zone 98 with no response type (00).
If a device such as a siren driver with a high-
U L
resistance trigger input (drawing less than 5mA)
is used in a UL Household Fire installation, the
siren driver must independently supervise siren
speaker wiring.
Disabling the Supervision of the Alarm Output
To install the alarm output and disable the supervision
feature, perform the following steps:
Step
Action
1
Wire the devices to terminals 4 and 5,
observing polarity if necessary.
2
Cut the blue jumper on the upper left-hand
corner of the panel's PC board.
3
Program Zone 98 with no response type (00).
Section 3 - Installing the Control
TO
OTHER
DEVICES
non_polar_devices
3-5
Advertisement
Table of Contents
