Figure 3-19: Installing The 5881Enhc With Tamper Protection - Honeywell VISTA-32FBPT Installation And Setup Manual

Installation and Setup of the 5881ENHC RF Receiver
Take note of the address you select for the RF receiver, as this address must be enabled in the system's Device
Programming in the #93 Menu Mode.
To install the 5881ENHC RF receiver, perform the following steps:
Step Action
1 Mount the receiver, following the advisories stated previously.
NOTE: Must be mounted in a 5800Box Enclosure.
2 Set the DIP switches in the receiver for the address (01-07). See Figure 3-19.
Make sure the address setting is not being used by another device (keypad, relay module, etc.).
3 If installing a 5881ENHC, install a flat-head screw (supplied) in the case tamper tab as shown in Figure 3-
20. When the receiver is pried from the wall, the tamper tab will break off and remain on the wall. This will
activate a tamper switch in the receiver and cause generation of a tamper signal. Note that this signal will
also be generated when the receiver's front cover is removed.
4 Connect the receiver's wire harness to the keypad terminals (11, 12, 13 and 14). Plug the connector at the
other end of the harness into the receiver.
5 Refer to the Installation Instructions provided with the receiver for installations regarding antenna
mounting, etc.

Figure 3-19: Installing the 5881ENHC with Tamper Protection

SCREW
5881ENHC-001-V0
40