Figure 3-17: Installing The 5881Enhc With Tamper Protection; Figure 3-18: 5881Enhc Rf Receiver (Cover Removed) - Honeywell VISTA-250FBPT Installation And Setup Manual

To install the 5881ENHC RF receiver, perform the following steps:
Step Action
1 Mount the receiver, following the advisories stated previously.
NOTE: Must be mounted in a 5800Box Enclosure.
2 Set the DIP switches in the receiver for the address (01-07). See Figure 3-18.
Make sure the address setting is not being used by another device (keypad, relay module, etc.).
3 If installing a 5881ENHC, install a flat-head screw (supplied) in the case tamper tab as shown in Figure 3-
17. When the receiver is pried from the wall, the tamper tab will break off and remain on the wall. This will
activate a tamper switch in the receiver and cause generation of a tamper signal. Note that this signal will
also be generated when the receiver's front cover is removed.
4 Connect the receiver's wire harness to the keypad terminals (11, 12, 13 and 14). Plug the connector at the
other end of the harness into the receiver.
5 Refer to the Installation Instructions provided with the receiver for installations regarding antenna
mounting, etc.

Figure 3-17: Installing the 5881ENHC with Tamper Protection

Figure 3-18: 5881ENHC RF Receiver (cover removed)

39