Resource Protect Mode; Auto Continue - Kyocera 1650 Advanced Operation Manual

Resource Protect Mode

The resource protect mode protects the resource data such as downloaded fonts and macros and
memorizes the PCL resources even if the emulation mode is switched. If you select Permanent,
temporary resources are not protected. If you select Perm/Temp, however, temporary resources
are also protected.
1
Display the Others screen. (See
2 Press the
Prot.
3 Press the Enter key.
4
Press the
Permanent or Perm/Temp.
5 Press the Enter key.
6 Press the Reset key. The message display returns to the printer basic screen.

Auto Continue

If any of the following error messages appears, the error can be cleared and printing can be
continued after the preset recovery time elapses (auto continue).
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Also you can set the time that elapses before auto continue is activated.
1 Display the Others screen. (See
2 Press the
Continue.
key or the key to select Resource
key or the key to select Off,
Memory Overflow/Press GO
Print overrun Press GO
KPDL error Press GO
File not found Press GO
HARD DISK error Press GO
RAM disk error Press GO
MemoryCard err Press GO
Illegal Account Press GO
Exceeded Max.out Press GO
Account error Press Go
Duplex disabled Press GO
Add Staples and Press GO
e-MPS not stored Press GO
Opt. ROM error Press GO
key or the key to select Auto
How to Display the Others Screen
Others
Resource Prot.
How to Display the Others Screen
Others
Printer Settings
on page 2-51.)
Print HEX-DUMP
Printer Reset
Resource Prot.
Back
Off
Permanent
on page 2-51.)
Printer Reset
Resource Prot.
Auto Continue
2-53