Staple Copying - Kyocera 1650 Advanced Operation Manual

Staple Copying

Copies can be stapled at the upper left or upper right corner.
Note
The optional finisher must be installed.
The relation between the orientation of originals and the stapling position is shown below.
1 Set the original.
2
Press the Staple key.
3 Press the
stapling position.
4 Press the Enter key.
5
Press the Start key. Scanning of the original starts.
If the originals have been set in the optional document processor, copying starts automatically.
If the original has been set on the platen, a message prompting replacement of the original is
displayed. In this case, proceed to the next step.
6 Replace the original and press the Start key. Scanning of the original is performed.
7
When all originals have been scanned, press the Enter key. Copying starts.
Original
Original
key or the key to select the desired
Copy
Copy
Staple:
Left Top
Right Top
Copier Functions
1-19