Interface; Parallel Interface - Kyocera 1650 Advanced Operation Manual

Printer Settings

Interface

This machine is equipped with a parallel interface, USB interface, and network interface as standard
components.
How to Display the Interface Screen
1 Press the Printer key.
2 Press the
3
Press the Enter key.
4 Press the
5 Press the Enter key. The Interface screen is displayed.
Next, perform the setting referring to the following description of each setting item.

Parallel Interface

The parallel interface of this machine supports a bi-directional/high-speed mode. The
transmission/reception modes that can be set from the operation panel of this machine are shown
below.
Mode
Auto
Normal
High speed
Nibble (high)
Note
Use a parallel interface cable that complies with the IEEE 1284 standard.
1 Display the Interface screen. (See
2 Press the
3
Press the Enter key.
2-16
key or the key to select MENU.
key or the key to select Interface.
Description
The printer automatically changes its communication mode according
to the connected computer. Normally, you should leave this setting
unchanged.
The printer uses the standard communication method prescribed for
Centronics interfaces.
This mode enables faster data transmission between the printer and
the computer. (Select this mode if printing problems occur when the
printer is connected to a workstation.)
High speed data communication is used in compliance with the IEEE
1284 standard.
key or the key to select Parallel.
Ready
Menu
How to Display the Interface Screen
Interface
GO
CANCEL
MENU
Back
Print Status Page
Interface
on page 2-16.)
Back
Parallel
Network