System Menu - PRESONUS StudioLive 16.0.2 Owner's Manual

5 Scenes, Presets, System Menu, and MIDI Control
5.4

System Menu

System Menu
5.4
• Pre 1: Sends each channel to the Aux bus after the
• Pre 2: Sends each channel to the aux bus after all Fat Channel parameters (Phase
• Post: Sends each channel to the Aux bus after all Fat Channel parameters (Phase-
POWER USER TIP: Use the Pre 2 position for headphone and in-ear mixes to
give your performers a polished "studio" sound. This setting should be avoided
for floor wedges, as compression can cause feedback problems!
46 46
From this menu, you can choose between three send positions for each Aux mix:
Phase Reverse, High Pass filter, and Gate.
Reverse, High Pass filter, Gate, Compressor, EQ, and Limiter) but before the fader.
Reverse, High Pass filter, Gate, Compressor, EQ, & Limiter), and after the fader.
If you have two Aux buses stereo linked, you only need to set the Pre
position on the Link Master. Remember, the Link Master is the Aux that
was selected when the link was created. To find out which Aux is the
Link Master, simply select either of the Aux buses in the pair. The Link
Master's ID will be shown in the Select Channel LED readout.
PreSonus StudioLive
In most digital-console manuals, the phrase "System
menu" inspires a sense of dread. However, with the
StudioLive, you have nothing to fear. The System menu
on the StudioLive serves just a few simple functions,
most of which have very little to do with mixing a show.
LCD Contrast and LCD Backlight.
Press the System button to access the System
menu. The first page allows you to adjust the LCD
Contrast and LCD Backlight for optimal viewing
in your working environment. These settings
are retained when the unit is powered down.
Aux Pre Position.
Press the Page Down button to access the Aux Pre
Position page. By default, all four Aux buses are set to
Pre 1. This places the send of all 16 channels to each
Aux bus before the fader, limiter, EQ, and compressor
and after the phase-reverse switch, high-pass filter,
and noise gate. The 2 internal effects buses are set
to Post, which sends each of the 16 channels after
all Fat Channel dynamics and EQ and the fader.
16.0.2
™