GE NetworX V3 Installation Manual page 89

Location Term
2.5.1.2.2.4 Medical/Aux 2
2.5.1.2.2.5 Keypress Tamper
2.5.1.2.2.6 LED Extinguish
2.5.1.2.3 Bypass
2.5.1.2.3.1 Auto Bypass
2.5.1.2.3.2 Code Required
2.5.1.2.3.3 Sounder Alert
2.5.1.2.3.4 Bypass Toggle
2.5.1.2.3.5 No Forced Bypass
2.5.1.2.4.1 Mains/Batt Sounder Alert
NetworX Version 3 Installation Manual
Definition
A menu option that activates a key with the Medical Alarm
function assigned, for all the keypads in the selected
partition (see This Keypad>Function Keys option
description). When this option is enabled and the Medical
Alarm key is pressed at the keypad, a medical alarm is
generated. See Programming the function keys on page
154.
Note: The report codes in slow formats sent for the keypad
aux 2 (medical) event are configured with the Control
Panel>Communications>Reporting>Report
Codes>Keypad>Keypad Aux 2 (Medical) menu option.
A menu option that disables the keypad for 60 seconds
and sends a tamper signal to the central station if 30 key
presses are entered without producing a valid code.
A menu option that enables or disables hiding status icons
on a display for the selected partition. If enabled, the status
icons disappear 20 seconds after the last key press (only
the power icon stays visible). There are two LED Extinguish
options (one for a partition and one for a keypad in This
Keypad menu), and both must be enabled for this feature
to work on a particular keypad in the particular partition.
When the user sets the LED Extinguish option for the
Control Panel to Enable then he must restart power supply
for the control panel. After restarting, this function will be
enabled.
When the user wants to disable this option he must set it to
Disable, and restart the power supply. The system then
waits for a valid user code. The LED Extinguish option gets
disabled after the user enters the user code (for example,
arm the system, accept an alarm, enter the user menu,
etc.).
To temporarily remove a zone from operation when arming
the system.
A menu entry that groups bypass options.
A menu option that automatically bypasses interior
follower zones if no exit is detected during the exit delay
time. The exit is detected by the opening and closing of an
entry/exit zone.
A menu option that specifies whether a user code is
required for bypassing zones.
A menu option that activates the keypad buzzer when a
user arms the system with one or more zones bypassed.
A menu option that allows an interior zone be bypassed or
included while the system is armed.
A menu option that disables auto bypassing of force
armable zones. Auto bypassing is enabled when this option
is set to No.
A menu option that causes the keypad sounder to beep
upon arming or disarming if the mains power is missing or
a low battery is detected.
89