GE NetworX V3 Installation Manual page 224

224
NetworX Version 3 Installation Manual
Term
Test Reports
Traceability
Transparent mode
Type
U
U/D Authentication
Disable Time
U/D Call Back after
Voice Call
U/D Port
Up/Download
Upload
Use V1.110
User ID
Using GSM Audio
Using GSM CSD
V
Version
X
XSIA
Z
Zone Bypass and
Restores
Zone Inactivity
Monitor
Zone Trouble and
Restores
Definition
A Reporting setting that sends a test report to the selected report control at pre-programmed
intervals. The units can be set in days or hours.
A menu entry that groups additional information, like serial number, manufacture date, and firmware
revision.
An operating mode for CSD on a GSM network. Data is transferred directly from one modem to
another modem.
An Options setting that displays the type of GSM modem used by the NX-7002.
An Up/Download setting that contains the length of time for which the system is disabled after the
maximum number of authentication attempts has been exceeded.
An Up/Download setting that starts an up/download session after a voice call.
An Options setting that indicates that configures the port for GPRS up/download.
A menu entry that groups options used to control download sessions between the up/download
software and the control panel.
The process of retrieving information from a PC running the upload/download software.
An Options setting that enables V.110 for site-initiated CSD GSM calls. Enable this setting if the PC is
on an ISDN line and is using an ISDN modem.
An Options setting that configures the user ID for a PAP login. Contact the network provider to
confirm if a PAP login is required and to obtain the user ID and password.
An Options setting that indicates that the module is using GSM audio. The GSM audio channel is used
when the panel reports through the voice channel of the GSM network.
An Options setting that indicates that the module is using GSM CSD.
See also CSD
A menu option that displays the current software version of the GPRS module.
Extended Securities Industry Association (reporting protocol). This adds a zone or user name when
appropriate to the report.
A Reporting setting that sends a report to the selected report control when a zone is bypassed. A
report is also sent when the zone is restored (un-bypassed).
A Reporting setting that sends a report to the selected report control when a zone inactivity event
occurs.
A Reporting setting that sends a report to the selected report control when a zone trouble condition
occurs. A report is also sent when the trouble condition is no longer active.