GE NetworX V3 Installation Manual page 188

188
NetworX Version 3 Installation Manual
Output Location
86
87
88
7
89
90
91
8
92
93
LOCATION 70 - PROGRAMMING THE EVENT, USER/ZONE AND TIME FOR OUTPUT 1 (3
segments, numerical data)
Segment 1 - Event
Selects the event that will trigger the output. See chart below for the specific events that can be
selected.
Segment 2 - Zone/user
Selects the zone or user number necessary to trigger an output. If this location is programmed as a
zero ("0"), any zone or user will activate the output (see also location 68). The zone/user filter is
active only for following events: Burglary Alarm, Fire Alarm, 24h Alarm, Zone Tamper (it filters out
zones for all these events), and Code Entry (it filters out users). For all other events this setting is
ignored.
Segment 3 - Time
Selects the amount of time an output will remain activated when an output triggers. If this location is
programmed as a zero, the output will follow the particular event.
Segment Type
3 dec value
1 option
2 option
1 hex value
2 hex value
1 dec value
2 dec value
3 dec value
1 option
2 option
1 hex value
2 hex value
1 dec value
2 dec value
3 dec value
1 option
2 option
1 hex value
2 hex value
Description
Time
Special configuration
Partition
X-10 unit code
X-10 house code
Event number
Zone / user number
Time
Special configuration
Partition
X-10 unit code
X-10 house code
Event number
Zone / user number
Time
Special configuration
Partition
X-10 unit code
X-10 house code
IO module
IO module 4