GE NetworX V3 Installation Manual page 223

Term Definition
SIA Securities Industry Association (reporting protocol).
SIA Comb'd Evts A menu entry that sets SMS reporting options so that events for separate account codes can be sent
in the same message.
SIA partition mods A menu entry that allows partition modifiers to identify partitions.
A menu entry that sets SMS reporting options so that events are grouped and sent as separate
SIA Single Evts
messages to separate account codes.
SIM card PUK code See PUK code
SIM PIN Accepted An Options setting that indicates that the PIN number for the SIM card has been entered correctly.
SIM PIN Code An Options setting that configures the code used to enrol the SIM card on the GSM network.
SIM PUK Required An Options setting that indicates that the SIM card has been blocked and a PUK code must be
entered to unblock it. Put the card into a mobile phone and enter the PUK code. When the card has
been unblocked put it back into the GPRS module.
Siren/Line Cut and A Reporting setting that sends a report to the selected report control when a siren or phone fault
Restores occurs. A restore report is sent when the fault is fixed.
Site Address A Reporting menu option that contains the site address.
Site Initiated An Up/download setting that allows an upload/download session between the NX-7002 and the PC
to be initiated from a keypad.
SM PSU Trouble An Options setting that indicates that there is a problem with its 3.8 V Switched Mode Power Supply
Unit.
SMS Short Message Service (SMS) is a service for sending short text messages to mobile phones.
SMS Reporting A Reporting menu entry that groups SMS reporting options.
SMS Service Centre An Options setting that configures the SMS service centre phone number. Usually, this number should
Address (SMCS) be left blank as it is dialled automatically by the SIM card. It should include the country code.
Software Revision An Options setting that displays the current software version of the GSM engine.
Speed An Options setting that configures the baud rate for CSD/GSM download. This setting must match the
baud rate set on the PC modem.
Status Check An Options menu entry that groups status messages for GSM events. See chapter 5 for more
information on status messages.
Switch to EN A menu option that switches the NX-7002 module to the EN 50131-compatible settings. For
additional information about the EN 50131 norm, see Appendix 7.
System Control An Options menu entry that groups together HomeText system settings.
T
Tamper/Fault A Reporting menu entry that groups together the tamper and trouble events that are reported to the
selected report control.
Tampers and A Reporting setting that sends a report to the selected report control when a tamper occurs. A report
Restores is also sent when the tamper is no longer active.
TCP/IP Alarm Port An Options setting that configures the number of the TCP/IP port to which polling and alarms are
reported. The default is 9999 and under normal circumstances should not be changed.
TCP/IP Reporting A Reporting menu entry that groups TCP/IP reporting options.
NetworX Version 3 Installation Manual
223