Aux Video Mode - Mercedes-Benz COMAND Operating Instructions Manual

Volume:
To select Volume Volume: turn and press the
X
controller.
Select Standard Standard or
X
Standard: the volume of the external audio Standard
source is adjusted to a standard value.
Boost: the volume of the external audio Boost
source is raised by approximately 10 dB.
The # dot indicates the current setting.
Traffic announcement:
To select TA TA: turn the controller and press
X
to confirm.
You have switched traffic announcements
on O or off ª.
A device which is connected as an external
audio source may seem quieter or louder in
the vehicle, or the usual maximum volume
cannot be achieved. On some devices, it is
possible to adjust the volume separately. In
this case, start at a medium volume and
increase it gradually. This enables you to
determine whether the system is able to play
the music at high volume without distorting
it.

AUX video mode

Connecting external video sources
G
WARNING
External video sources may have different
volumes, which can mean that system
messages such as traffic announcements and
navigation system announcements are much
louder. If necessary, please deactivate the
system messages or adjust their volume
manually.
Video AUX is a further option for showing
videos via COMAND.
To connect an external video source to the
video AUX, you will require a video AUX cable.
Boost. Boost
AUX video mode
i
If you only use an audio AUX cable, you
will only be able to hear the sound from the
video being played.
Videos cannot be shown on the driver's
side while the vehicle is in motion.
Switching to AUX video mode
Connect the external video source.
X
The socket for the video AUX jack is located
in the stowage compartment in the center
console.
The video AUX is not selected
automatically.
Press the Õ button.
X
The menu for the last accessed media
source appears.
To select Media Media in the main function bar:
X
turn the controller and press to confirm.
You will see the menu.
Select AUX AUX.
X
The AUX video menu appears.
To select Audio/Video Audio/Video
X
slide V¬ and press the controller.
A Source Type Selection Source Type Selection
appears.
Select Video. Video
X
The # dot indicates the current setting.
If the video source is connected and
playback selected, the image from the
external video source will appear if
is selected.
Please see the corresponding device
operating instructions for information on how
to operate the external video source.
Information on:
Sound settings: (
R
Y
in the menu bar:
menu
Video Video
page 230)
Z
219