Mercedes-Benz COMAND Operating Instructions Manual page 87

Using map
Crosshair
:
Distance of crosshair position from current vehicle position
;
To switch to navigation mode: press the ß button.
X
To show the menu: press the controller.
X
To select Destination Destination: turn and press the controller.
X
Select Using Map Using Map.
X
The map with crosshair is shown.
To move the map: slide XVY, ZVÆ or aVb the controller.
X
To change the map scale: turn the controller until the desired map scale is selected.
X
The scale is displayed at the bottom. Turning clockwise zooms out from the map; turning
counter-clockwise zooms in.
To select a destination: press the controller.
X
If the digital map provides navigable address data, you will see the destination address in
the address entry menu. If not, the
If there are multiple destinations around the crosshair, a selection list will appear.
To select a destination from the selection list: turn and press the controller.
X
To start route calculation: select
X
Entering way points
Introduction
You can also map the route to the destination
yourself by entering up to four way points. The
sequence of the way points can be changed
at any time.
COMAND provides a selection of predefined
destinations in eight categories for this
purpose, e.g. GAS STATION GAS STATION
Destination from Map Destination from Map
Start. Start
You can also use the destination entry
options to enter way points.
or COFFEE COFFEE SHOP SHOP.
Destination input
entry is shown.
85
Z