Mercedes-Benz COMAND Operating Instructions Manual page 244

Rear Seat Entertainment System overview
242
Selecting the screen for the remote
control
You can use the remote control to operate
one of the two rear screens at a time. To do
so, you must switch the remote control to the
desired screen.
To select the left-hand screen: turn
X
thumbwheel : until "L REAR" appears in
the window.
To select the right-hand screen: turn the
X
thumbwheel until "REAR R" appears in the
window.
To select the COMAND screen: turn
X
thumbwheel : until "COMAND" appears
in the window.
i
Please be aware that using the
thumbwheel to select screens may cause
unwanted changes to the screens of your
occupants.
Up to four remote controls can be used in
the vehicle at the same time.
Switching the screen on/off
If the SmartKey in the ignition lock is in
position 0 or 1, or if the SmartKey is not in
the ignition lock, the rear screens will switch
off after 30 minutes. Before the screens
switch off, they show a message to this effect.
You can switch the screens back on.
i
Please note that this may cause the
starter battery to discharge.
Press button : on the remote control.
X
The respective rear-compartment screen
switches on or off.
i
You can only switch the screens on using
the remote control if the ignition is
switched on.
Switching the button lighting on/off
Lighting of the remote control buttons is
X
divided into three areas. The corresponding
area is activated every time you press a
button. It switches off again automatically
5 to 10 seconds after the last button has
been pressed.