1. Turn the unit off and allow it to cool down to room temperature.
2. Shut off the gas and power supply to the unit.
3. Remove the faceplate (see detailed instructions in this manual).
4. Remove the mesh barrier (see manual) and glass door.
a) Remove the 2 screws shown below at the bottom of the glass
.
door
b) Swing the door out 45
o
5. Remove the burner tray cover by lifting up and out as shown below.
* Prior to removing burner - remove crystals, pebbles, spa stones and inner
panels - if installed.
6. Loosen 2 screws at the back of the burner to release it.
VALVE ASSEMBLY REPLACEMENT
from the bottom and lift up and out.
7. Remove the burner by sliding it to the right - then lift out.
8. Remove the valve access plate by undoing the 17 outer screws - see
locations below.
Location of screws on access plate
Regency Horizon HZ30E-10 Gas Fireplace
maintenance
|
55
|
55