Regency Horizon HZ30E-NG10 Owners & Installation Manual page 48

installation
|
48
MESH SCREEN / INNER DOOR FRAME REMOVAL/INSTALLATION
MESH SCREEN / INNER DOOR FRAME REMOVAL/INSTALLATION
1. The inner door frame (1) and screen mesh (2) come attached to the fi replace.
Remove the inner door frame (held by magnets) and screen by pulling the
bottom of the frame towards you as one, then lift up.
1
2. Remove screws from inner side of the inner door frame and discard screws
and the brackets. (Brackets not shown). Remove the screen mesh from
inner door frame.
3. Install screen into inner door trim (3). Secure screen by bending down the
6 tabs as shown
48 |
Regency Horizon HZ30E-10 Gas Fireplace
2
3
Screw Locations
Tabs
4. Hook the outer door frame (3) and mesh screen (2) assembly over
the inner door frame.
5. Bend the center tab up and secure with a screw to attach the outer
frame/mesh assembly to the inner door frame
6. Attach the completed assembly to the glass frame on the fi replace.
7. Secure the assembly with screws on each side as shown below.
Regency Horizon™ HZ40E-10 Gas Fireplace
|
1
| 1