Regency Horizon HZ30E-NG10 Owners & Installation Manual page 40

installation
|
40
11. Slide the thermodisc/cover assembly on to the bracket clip on the
bottom of the unit. Ensure no wires will touch the hot surfaces.
12. The fan control module (supplied with the fan kit) secures to the floor
of the unit with a Velcro pad. The front of the fan control module
should face to the left directly in front of the fan. Plug the fan control
module into the outlet in the unit.
13. Plug in the fan power cord to the Fan Control Module into the outlet
marked "Fan". Plug the FCM-COM wire from the remote control wiring
harness into the location on the Fan Control Module marked "COM".
Turn the switch on the Fan Control Module to the ON position. ON is
to the left. The "O" is the off position
40 |
Regency Horizon HZ30E-10 Gas Fireplace
14. See the Proflame Remote installation instructions for coding the
remote handheld to the receiver as well as the operating instructions
15. Reverse steps 6 through 1 to complete the installation.
Note: The HZ30-10 does not have BTU turndown therefore this
feature is inactive on the GTMF remote.
TO REMOVE THE FAN
1) Turn off the power
2) Reverse the steps from the above instructions.
MAINTENANCE: The sealed bearings are lubricated so there is no
need to lubricate them further. Extra lubricant will cause more lint to
and dust to build up causing the premature failure of the bearings.
Regular cleaning and vacuuming of the fan area will add to the life of
the motor
IMPORTANT:
These fans collect a lot of dust from within your home.
Ensure you maintain these fan motors on a regular
basis by vacuuming the fan blades and the housing with
a soft brush nozzle.