Table of Contents
Advertisement
1. Construct the wood framing, ensure inside dimensions are 34-3/8"W x
36-7/8"H as shown below.
36-7/8"
2. Bend both side nailing strips from the side of the appliance until
positioned as shown below.
Determine the overall combined thickness of the non-combustible board
+ finished material being used. The nailing strips can be adjusted up to
3-1/8".
3. Adjust the nailing strips by loosening 2 screws on each nailing strip -
adjust and retighten screws.
4. Attach both vertical studs and secure using 6 screws (2 at bottom, 2 at
top and 2 on sides) as shown.
NOTE: Ensure the flat side of the steel stud is facing the wood framing.
OPTIONAL FRAMING KIT
OptiOnal framing kit
Nailing Strips
Flat side out
5. Secure horizontal steel header stud with 2 screws per side as per
diagram.
Header stud
6. Slide the unit into position. Hook up gas, venting, electrical and fan (if
purchased) prior to installing the remaining steel studs.
7. Secure the large horizontal steel stud as shown with 2 screws per side.
8. Secure the horizontal stud on the lower side of the appliance with 2
screws per side.
Large stud
Horizontal
stud
Regency Horizon HZ30E-10 Gas Fireplace
installation
|
HZ30E
15
|
15
Advertisement
Table of Contents
