Inspecting the Cylinder Block and Components
12/05
Replacing Freeze Plugs
Step
No.
1
1 – Cylinder Block
2 – Hammer
3 – Screwdriver
4 – Plug
2
1 – Clean and Apply Adhesive
3
1 – Jig
4
6LY3 Service Manual
Description
(1)
(2)
(3)
(4)
0005589
(1)
0005590
(1)
0005591
0005592
© 2007 Yanmar Marine International
Procedure
Set the screwdriver at a slight angle in
the upper portion of the plug. Tap lightly
with a hammer and remove the plug.
Wipe the cylinder block and plug
opening clean. Apply an adhesive
agent (acrylic) on the outside surface of
the plug and cylinder block opening.
Insert the plug using a driver and
hammer. (Drive the plug straight into
the opening.)
Do not add coolant to the cylinder block
for two hours after the plugs are set.
ENGINE
Tool or Material Used
• Screwdriver
• Hammer
• Thinner
• Adhesive agent
(or Three Bond
®
1386B)
• Driver
• Hammer
—
5-23