Rocker Switch Panel - Yanmar 6LY3 series Service Manual

Remote Control Electronic Control System (ECS)
12/05

Rocker Switch Panel

st
1 Station Panel
1. ON-OFF-START switch
(Figure 12-35, (5)).
2. Emergency stop switch (Figure 12-35, (3)).
The engine shuts down when the top of the
emergency stop switch is pushed. Push the
bottom part of the switch after the engine has
shut down and return the switch to the former
setting. (Restarting the engine after using the
emergency stop may be slower or difficult.) Use
this switch only in an emergency.
Figure 12-35
(1)
Start
Eng ON
OFF
(5)
Figure 12-35
1 – Sub-Throttle Lamp
2 – Sub-Throttle
3 – Emergency Stop Switch
4 – Rocker Switch Panel
5 – ON-OFF-START Switch
6LY3 Service Manual
(2)
Emergency
Stop
(4) (3)
0006298
© 2007 Yanmar Marine International
ELECTRICAL AND ECU
3. Sub-Throttle control
• If the main throttle control fails, the sub-throttle
lamp (Figure 12-35, (1)) will flash. The engine
speed is then controlled by using the
sub-throttle (Figure 12-35, (2)).
• Engine speed increases when the sub-throttle
knob is turned clockwise.
• When the sub-throttle lamp flashes, turn the
sub-throttle knob counterclockwise to the end
and turn the knob clockwise gradually until the
sub-throttle lamp is steady.
• Each engine is controlled by its own
sub-throttle controller.
2nd Station Panel (Optional)
1. ON-OFF-START switch is wired to the 1st
station panel.
2. Able to start and stop the engine from the 2nd
station panel (Figure 12-36, (1)).
3. Emergency stop switch is wired in series with
the 1st station panel.
Figure 12-36
Start
Eng ON
OFF
Figure 12-36
1 – 2nd Station Panel
Emergency
Stop
(1)
0006312
12-23