Yanmar 6LY3 series Service Manual page 160

FUEL SYSTEM
3. Install the pump bottom bracket
(Figure 6-18, (2)) as shown in Figure 6-18 and
tighten to the specified torque value.
Bottom Bracket Bolt Torque
Tightening Torque
Figure 6-18
Figure 6-18
1 – M10 x 80 mm Bolts (4)
2 – Pump Bottom Bracket
6-18
49 ± 5 N·m
(5.0 ± 0.5 kgf·m)
(36.1 ± 3 lb-ft)
(1)
(2)
0005680
© 2007 Yanmar Marine International
Fuel Injection Pump / Governor / Timer
4. Install the spring pins (Figure 6-19, (1)) and
guide bracket (Figure 6-19, (2)) into position.
Figure 6-19
(1)
Figure 6-19
1 – Spring Pins, 4.0A x 10
2 – Guide Bracket
3 – Nut, M8
5. Install nuts (Figure 6-19, (3)) and torque to the
specified value.
Guide Bracket Bolt Torque
Tightening Torque
®
6. Apply Three Bond
the drive shaft housing mating surface of the
timer housing.
Figure 6-20
Figure 6-20
1 – Apply Three Bond
6LY3 Service Manual
(2)
(3)
0005681
25.5 ± 3 N·m
(2.6 ± 0.3 kgf·m)
(18.8 ± 2 lb-ft)
1207C (Figure 6-20, (1)) to
(1)
0005682
®
1207C